What are the minimum sensors needed to run the engine? The absolute minimum wires needed is listed below When running the ecu standalone the immobiliser needs to be removed, this requires a CR1 deimmo fitted and a small 24c04 chip to be reprogrammed to suit. The stock ecus can be remapped to run completely standalone like in a swap just requiring minimal sensors and 2 wires for power along with common ground. But if your racing or drifting i suggest get the larger elements fitted and this will help reduce injection time along with egt, larger element are sufficient for around 380hp(om605) 450hp(om606) these need to be confirmed by dyno. These levels of power are fine for daily driving blasts and fun etc. Some power figures quoted for a stock 6mm edc pump are 250hp(om605) and 300hp(om606) these are realistic figures although i would not suggest building a car to stay at this level for long period of time. What power levels are possible with either? The stock 6mm edc pump can put out about 90cc at the rack limiter, All 5 and 6 cylinder edc pumps can also be upgraded with dieselmeken 7,5 and 8mm elements, giving upto 170cc with reduced. What pumps and injection quantity can EDC achieve? I will try answer the most commonly asked questions and even some questions not asked but to give some knowledge back so people can better understand for their own projects. To answer some commonly asked questions about edc pump and om605/6 ecus.Īs this is a community that i have learned so much from.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |